Features

– 64-bit high voltage output

– High current driver (600 mA sink current)

– Inrush current auto shutdown protection option

– Thermal shutdown protection www.cniacs.com option for driving incandescent lamps or inductive loads

– High breakdown voltage (55 V)

– Output clamp diode for inductive flyback protection

– Compatible with intelligent I/O controllers

– Built-in test logic for fault isolation

– Highly reliable DIN-type I/O connectors

– 8-, 16-, or 32-bit transmission

– Dual Eurocard form factor

– Separate board address decoding for control and data registers

– Optional pull-up resistors for electronic switch outputs

– Optional TTL outputs

– Front Panel with Fault LED

Functional Features

Compatibility: Compatible with VMEbus specification.

Double height form factor.

Output Connector Type: Dual 64-pin connector DIN 41612.

Output Organisation Eight ports, eight bits wide.

Addressable to any address within the Short-Circuit Monitor or Short-Circuit Unprivileged I/O map. Control and Status Register (CSR) addresses are independently selectable.

Address Modifier Codes: Short-circuit supervisory or short-circuit unprivileged I/O access can be selected via jumpers.

Factory configured for short-supervised I/O access.

Addressing Scheme: Eight ports can be individually addressed on 8-bit, 16-bit, or 32-bit boundaries.

CSR’s separate board address decoder allows hardware control addresses to be grouped for software efficiency.

Data Transfer Bus: A16: D8. D16. D32

Built-in Test: This product supports offline and real-time fault detection and isolation. Offline mode can be enabled by writing the CSR Set Test Mode bit.

When test mode is enabled, all outputs are off. When test mode is enabled, all outputs are off.