Preparing for Installation

Lifting the inverter

Lift the inverter by holding the base of the inverter only.

Opening the packing box

1. Open the packing box.

2. Check for damage. If any damage is found, notify the carrier immediately. 3.

3. Check that the contents of the box correspond to the order and the waybill.

Identification of the inverter

To find out which inverter you are installing, refer to the following

– The label on the top of the bar code between the mounting holes.

– Model code on the heat sink – located on the right side of the inverter cover:

Motor Compatibility The motor, inverter and power supply must be compatible:

Tool Requirements The following tools are required to install the ACS510:

– Screwdriver ( to match the fasteners used)

– Wire stripper

– Tape measure

– Drill