Overview

The 1746-N3 Connector Kit is used to terminate a cable which connects field I/O 

devices to SLC 500 32-point I/O modules. The kit contains a keyed 40-pin socket 

header with 45 socket crimp type contacts.

The N3 connector is compatible with 32-point I/O modules, catalog numbers 

1746-IB32, -IV32, -OB32, -OB32E -OV32 and Allen-Bradley 1492-IFM40 terminal 

blocks (see illustration). When the 1746-N3 is used to terminate the I/O cable at the 

1492-IFM40 end, it should be wired in a straight-through manner (i.e. pin 1 to pin 1, 

pin 2 to pin 2, etc.). For additional instructions, refer to the wiring instructions 

provided with your 32-point I/O module.

Use 24 AWG wire with the 1746-N3. Maximum wire length to the user terminal 

block is 10 meters for inputs and 3 meters for outputs with 7-strand, 24 AWG wire.

Assembly Procedure for Crimp Contacts

The following details the assembly procedure for the crimp type contacts.

1. Strip the wire insulation as shown in Figure 1.

2. Insert the wire up to the wire stop as shown in Figure 2.

3. Crimp with DDK crimp tool 357J-5538. Equivalent Amp part numbers are: 

pin – 87666-2, connector – 102387-9, and crimp tool – 90418-1.

If a crimp tool is not available, used the following crimping procedure:

a. Crimp the wire barrel around the wire using a small needle nose pliers.

b. Crimp the insulation barrel around the wire insulation using a small 

needle nose pliers.

c. Solder wire and wire barrel together.

4. After completing above assembly, insert the cable into the socket housing as 

shown in Figures 3 and 4. Check to make sure that the tang, shown as “A” in 

Figure 4, is properly latched by gently pulling on the wire.