Disable Web Server in Static IP mode

1. Set the switches to 901 and cycle power to the adapter.

The module LED flashes red and the four-character status display scrolls

the message “Web Server Disabled”.

2. Set the switches to the desired IP address and cycle power to the adapter.

3. In your web browser, enter the IP address of the adapter.

The web server home page does not display.

Enable Web Server in DHCP mode

Before you begin, verify that you have an active DHCP server on your network.

1. Set the switches to 000 and cycle power to the adapter.

The module LED flashes red and the four-character status display scrolls

the message “Web Server Enabled”.

2. Set the switches to 999 and cycle power to the adapter.

3. In RSLinx software, check the IP address that was assigned to the

adapter by the DHCP server and verify the connection.

4. In your web browser, enter the IP address of the adapter.

The web server home page displays.

2. Set the switches to 999 and cycle power to the adapter.

3. In RSLinx software, change the Port Configuration setting to “Manual

IP”, set the desired IP address, and cycle power to the adapter.

4. In your web browser, enter the IP address of the adapter.

The web server home page does not display.