Shut-off function

This parameter can be set separately for each end position.

When the respective configured limit value is exceeded, the

shut-off function causes immediate travel of the actuator until

reaching the set end position.

If the value “0” is entered for the corresponding parameter, the

position is further controlled, even in the respective end

position.

Travel time prolongation

This function can be used to increase the max. travel time for

full travel. This time parameter can be set separately for each

direction.

This function can only be used with the pneumatics with the

safety function “fail-safe”.

Switching points for the position

You can use these parameters to define two position limits for

signaling (see option “Module for digital position feedback”).