Din Rail Alignment Requirements

1. Confirm that the DIN rail is in a horizontal position before installing the unit.

Horizontal orientation is required to avoid module slippage on the DIN rail.

2. Align the unit on the DIN rail then push the DIN rail clip to until it clicks in to place.

Check to ensure that the unitis secure on the DIN rail.

Mounting Orientation

NOTE: Do NOT mount the unit on its side as this may cause the unit from slipping off the DIN rail.

l Mount the CPU300 with the locking DIN tab facing down.

l As modules mount on a DIN rail, be certain that the DIN rail is in a horizontal position before installing the unit. 

A horizontal orientation is required to prevent the unit from slipping off the DIN rail.

Module Removal

Modules maybe removed while powered;however,I/O scanning on the remaining modules will stop

and I/O will go into  the default state until a new module is inserted and all modules in the configuration are present.

1.Insert a flat-blade screwdriver into the DIN rail latch at the bottom of the module.

2.Pry down wards on the release latch.

3.Rock the module up and off the DIN Rail.