Features

• Single- or three-phase use

• High-set overvoltage stage with definite-time or inverse definite minimum time

(IDMT) characteristic

• Low-set overvoltage stage with definite-time or IDMT characteristic

• High-set undervoltage stage with definite-time or IDMT characteristic

• Low-set undervoltage stage with definite-time or IDMT characteristic

• Positive-phase-sequence protection

• Adjustable drop-off/pick-up ratio for the low-set over and undervoltage stages

• Circuit-breaker failure protection (CBFP)

• Disturbance recorder

• recording time up to 12 seconds

• triggering by a start or a trip signal from any protection stage and/or by a binary

input signal

• records three analogue channels and eight digital channels

• adjustable sampling rate

• Non-volatile memory for

• up to 60 event codes

• setting values

• disturbance recorder data

• recorded data of the five last events with time stamp

• number of starts for each stage

• alarm indication messages and LEDs showing the status at the moment of

power failure

• Three accurate voltage inputs

• Galvanically isolated binary input with a wide input voltage range

• All settings can be modified with a personal computer

• HMI with an alphanumeric LCD and manoeuvring buttons

• IEC 60870-5-103 and SPA bus communication protocols

• Two normally open power output contacts

• Two change-over signal output contacts

• Output contact functions freely configurable for desired operation

• Optical PC-connector for two-way data communication (front)

• RS-485 connector (rear) for system communication

• Continuous self-supervision of electronics and software. At an internal relay fault

(IRF), all protection stages and outputs are blocked.

• User-selectable rated frequency 50/60 Hz

• User-selectable password protection for the HMI

• User-selectable nominal voltage 100/110/115/120 V

• Display of primary voltage values

• Demand values

• Multi-language support