In-drive PLC

With a cycle time of 100 µs for 1.000 lines of STL, the

b maXX-drivePLC is suitable for both compre hensive control

and demanding motion control tasks. Through the use of our

drivePLC, the PLC can be assisted, down-sized or even

completely replaced. A new transparency and clarity is also

created in the application via the clean decoupling of motion

control applications from the machine program. The drivePLC

can be integrated into the b maXX 4400 servo controller series

and enables the uncomplicated creation of control technology

programs with ProMaster or PROPROG.

A CANopen master is included with the CAN option module for

b maXX-drivePLC. This enables up to 65.536 digital I/O points

to be switched. With the existing EtherCAT master challenging

and highly synchronized movement processes are controlled

directly on the b maXX-drivePLC. The extensive product range

includes decentralized analog and digital I/O modules.

The program memory of the b maXX-drivePLC is sufficient for

typical 120.000 lines of IL. 2 MB of RAM are available for variables.

The optional residual data memory of 100 KB is buffered battery-free

with a NVRAM. This means there is enough memory available for

sufficient code. Costly memory expansions can be dispensed with.

The battery-free NVRAM means that data is available maintenance

free and after every time the system is switched off and on without

any data loss.

• 32-bit Risc CPU 120 MHz

• 16 MB flash memory, of which

2 MB is reserved for the IEC program and 4 MB for cams

• 100 KB non-volatile RAM