The IC200CH003 is a connectorized I/O carrier from GE Fanuc Automation.

The IC200CH003 I/O carrier weighs 0.113 kg and has a 36-pin connector for input/output cables.

The carrier provides backplane communication, mounting, and field wiring for one input/output module.

You will find a module latch hole for securing the module to the carrier.

The carrier also provides quick connections for wiring up to 32 input/output points and 4 common power connections.

During rail mounting, the IC200CH003 I/O bracket snaps easily into the DIN rail.

The dimensions are as follows: 7.5 mm x 35 mm: 7.5 mm x 35 mm.

For EMC protection, the DIN must be electrically grounded. The rail must also be electrically conductive and corrosion resistant.

The field wiring can be connected directly to the connector itself by means of contacts crimped onto the end of the wires.

I/O devices can be connected directly to the mating I/O terminals. To install a prewired connection cable, place the cable connector over the connector on the carrier and press down until the latch engages the connector.

To remove the cable, you must hold the connector and press the latch upward to release the connector.

Occasionally, the operating equipment may become hot due to high ambient temperatures. In this case, handle the connector carefully.

Do not touch them directly. Also, avoid exposed connector pins.