About the IC200ERM002

The GE Fanuc IC200ERM002 module is a non-isolated expansion receiver module that is part of the Versamax family.

This expansion module is used to enhance the functionality of a Versamax PLC or I/O output station and also increases the number of modules that can be connected.

The IC200ERM002 Expansion Module has a **capacity of 7 racks with up to 8 modules per rack*.

It requires an installed power supply to power all connected devices.

When an additional power supply or booster carrier is used, it should be connected to the mains power supply on the IC200ERM002 Expansion Module.

It also features 3 on-board LEDs to indicate the operational status of the device.

The module can also be used as a single-ended or multi-rack Versamax I/O expansion system.

Where the module is used in a multi-rack implementation, the total cable length cannot exceed 50 feet or 15 meters.

When the Versamax GE Fanuc IC200ERM002 Non-Isolated Expansion Receiver Module is used in a single-ended system with only 1 expansion rack, the

The cable length should not exceed 3.3 feet or 1 meter.

It has a data rate of 2.765 Mbps or 5 Mbps, depending on the implementation used.

The GE Fanuc IC200ERM002 expansion module is equipped with two 26-pin D-shell expansion female ports.

In addition, it has two different current consumption ratings with a 3.3 volt or 5 volt backplane rating.

When the backplane voltage is 5 volts, the current consumption is rated at 70 milliamps and when the backplane voltage is rated at 20.3 volts, the current consumption is rated at 3 milliamps.