Programmer Connection, Parallel

For a parallel interface (MS-DOS programmer only)

connect the programmer to the top port connector on

the Bus Transmitter Module (IC697BEM713) as shown

in Figure 1.  Consult  Reference 2 for a description of

programming functions.

Serial Port

The 15-pin D-connector provides the connection to an

RS-485 compatible serial port as shown in Figure 3.

This port provides a serial connection to a Standard

Serial COM port, or to a Work Station Interface board

installed in the programming computer. For more in

formation on serial communications, see references 1.

2. and 3.

Programmer Connection, Ethernet TCP/IP

Connecting your programmer via an Ethernet

TCP/IP network requires installation of an Ethernet

Interface module in the PLC.  This can be either the

Ethernet Controller, IC697CMM741. or Ethernet

Interface (Type 2), IC697CMM742.  Before connecting

your programmer and PLC to the Ethernet TCP/IP

network you must set the IP address in the Ethernet

Interface.  After setting the IP address, connect the

PLC and the programmer running Windows software

to the Ethernet Interface.  For more detailed

information on the programmer connection via

Ethernet TCP/IP, refer to the TCP/IP Ethernet

Communications (Type 2) User’s Manual, and the

Windows programming manual, GFK-1295.