Register-Level Programming

The final option for programming any National Instruments DAQ

hardware is to write register-level software. Writing register-level

programming software can be very time-consuming and inefficient and

is not recommended for most users.

Even if you are an experienced register-level programmer, consider

using NI-DAQ, LabVIEW, or LabWindows/CVI to program your

National Instruments DAQ hardware. Using the NI-DAQ, LabVIEW, or

LabWindows/CVI software is as easy and as flexible as register-level

programming and can save weeks of development time.

Optional Equipment

National Instruments offers a variety of products to use with your

PC-LPM-16/PnP board, including cables, connector blocks, and other

accessories, as follows:

• Cables and cable assemblies, shielded and ribbon

• Connector blocks, shielded and unshielded with 50-pin screw terminals

• SCXI modules and accessories for isolating, amplifying, exciting,

and multiplexing signals for relays and analog output. With SCXI

you can condition and acquire up to 3,072 channels.

• Low channel-count signal conditioning modules, boards, and

accessories, including conditioning for strain gauges and RTDs,

simultaneous sample-and-hold circuitry, and relays

For more specific information about these products, refer to your

National Instruments catalogue or call the office nearest you.