Hardware Installation

You can install the PC-LPM-16PnP in any available expansion slot in

your computer. The following are general installation instructions, but

consult your computer user manual or technical reference manual for

specific instructions and warnings.

1. Turn off and unplug your computer.

2. Remove the top cover or access port to the I/O channel.

3. Remove the expansion slot cover on the back panel of the computer.

4. Insert the PC-LPM-16PnP board into any 8-bit or 16-bit slot. It may

be a tight fit, but do not force the board into place.

5. Screw the mounting bracket of the PC-LPM-16PnP board to the

back panel rail of the computer.

6. Replace the cover.

7. Plug in and turn on your computer.

The PC-LPM-16PnP is installed.

Software Installation

If you are using NI-DAQ, refer to your NI-DAQ release notes to install

your driver software. Find the installation section for your operating

system and follow the instructions given there.

If you are using LabVIEW, refer to your LabVIEW release notes to

install your application software. After you have installed LabVIEW,

refer to the NI-DAQ release notes and follow the instructions given

there for your operating system and LabVIEW.

If you are using LabWindows/CVI, refer to your LabWindows/CVI

release notes to install your application software. After you have

installed LabWindows/CVI, refer to the NI-DAQ release notes and

follow the instructions given there for your operating system and

LabWindows/CVI.

If you are a register-level programmer, refer to Appendix D, Register-

Level Programming, for software configuration information.