The EK1100 EtherCAT Coupler is the link between the EtherCAT protocol at fieldbus level and the EtherCAT Terminals. The coupler

converts the passing telegrams from Ethernet 100BASE-TX to E-bus signal representation. A station consists of a coupler and any

number of EtherCAT Terminals that are automatically detected and individually displayed in the process image.

Special features:

Connection technology: 2 x RJ45 socket

Connection lengths: up to 100 m

Number of EtherCAT Terminals in the overall system: up to 65.535

The EK1100 has two RJ45 sockets. The upper Ethernet interface is used to connect the coupler to the network; the lower socket

serves for the optional connection of further EtherCAT devices in the same segment. In addition, an EtherCAT junction or an

EtherCAT extension can be used for the extension or for setting up a line or star topology.

The system and field supply, each 24 V DC, is provided directly at the coupler. The attached EtherCAT Terminals are supplied with

the current required for communication from the supplied system voltage. The coupler can supply a maximum of 5 V and 2 A. If

higher current is required, power feed terminals such as the EL9410 have to be integrated. The field supply is forwarded to the

individual I/O components via the power contacts with up to 10 A.

In the EtherCAT network, the EK1100 can be installed anywhere in the Ethernet signal transfer section (100BASE-TX) – except

directly at the switch. The EK9000 and EK1000 couplers are suitable for use at the switch.