What the module does

The module processes and extracts cyclic injection molding data for 

display on your PC, and responds to alarms that you set to monitor 

critical molding parameters. 

When used with the Pro-Set 200 Injection Molding Control System, 

the module helps you:

• achieve a quicker setup time to obtain optimum part quality

• maintain that quality over the production run

The module and associated DARTWin software help you to set up the 

injection molding machine for optimum performance. Then you set 

alarm limits on critical parameters to detect deviations while making 

parts. You can also set a critical mold pressure to transfer the injection 

process each machine cycle. 

The module is designed for use with the SLC 5/03 (or later) processor. 

You program it to interface with the injection molding machine. The 

module has two independent channels to accept analog pressure inputs 

from sensors or from the SLC processor across the backplane. It 

returns alarm signals and processed molding parameters to the SLC 

processor for your application programming and to your PC for 

graphic display. We show the module in a typical Pro-Set 200 system.

Wiring Notes

• Ground cable shields at one end only.

• Isolate signal wiring from power lines and sources of electrical noise.

• Do not exceed 10V dc on any input terminal.

• Outputs +Exc, +T/R, and -T/R must have a minimum load of 1K ohms.

referenced to analog common.