Identify Module Features

Refer to the following figure to identify the hardware components of the 56AMXN/B module.

The module has:

• A label to indicate that it is a scanner for AutoMax

DCSNet and remote I/O

• A 4-character scrolling display (XXXX)

• 3 LEDs, labelled NET, CLX, and OK, to indicate the

status of the network, the connection to the ControlLogix processor, and its own internal state

• a 9-pin D-shell connector to connect to the DCS or remote I/O network

• switches at the top of the module to set the mode of operation and the drop number and drop depth

For example, to configure the 56AMXN/B as a DCS slave with drop number 17,

drop depth 5, set the switches to 0, 5, 1, and 7 from left to right.

Any other settings are invalid and result in the module going into “Thumbwheel

test” mode. In thumbwheel test mode, the display shows the current switch settings.

It doesn’t go out of thumbwheel test mode until you cycle power.

In thumbwheel test mode, the 56AMXN/B initially displays “Thumb Test Mode”

on the 4-character display, displays the switch settings for 5 seconds, then resumes

displaying “Thumb Test Mode”

For DCS slave operation, if the drop number and drop depth are individually valid

but the combination results in invalid drop numbers (for example, drop number 55,

drop depth 2), the module displays an error message on the 4-character display but

does not enter Thumbwheel test mode.

Prepare the Chassis for Module Installation

Before you install the 56AMXN/B module, you must install and connect a

ControlLogix chassis and power supply.