Introduction

Read these instructions carefully and inspect the equipment to

become familiar with it before trying to install, operate, service, or

maintain it .

Electrical equipment should be installed, operated, serviced, and

maintained only by qualified personnel .  Local safety regulations

should be followed .  No responsibility is assumed by Eaton for any

consequences arising out of the use of this material .

Eaton reserves right to changes without further notice .

Abbreviations

CB – Circuit breaker

CBFP – Circuit breaker failure protection

EMC – Electromagnetic compatibility

EPROM – Erasable programmable read only memory

HW – Hardware

LED  – Light emitting diode

LV  – Low voltage

ms – Millisecond

MV – Medium voltage

NC – Normally closed

NO – Normally open

PMSG – Permanent magnet synchronous generator

Rx – Receiver

SF –    System failure

SW – Software

Tx – Transceiver

uP2– Microprocessor