Features

The actuator output is an ISO 9409 flange. This allows for easy mounting of levers to

simplify replacement. The orientation of the output flange relative to the bracket base

is the same for each actuator. Additionally, the actuators are equipped with break-away

stops that prevent the actuator from exceeding the maximum output travel range

during setup. An output position indicator is standard.

The EM-80 and EM-300 systems include a mounting bracket with hole pattern. The

bracket design ensures that stresses in the actuator are reduced to a minimum.

Actuator specifications and performance are based on a system including bracket.

The actuators are equipped with a flying-lead position-sensor cable (including connector).

A position sensor cable connecting the actuator and the driver is available.

This cable is similar for both the EM-80 and the EM-300.

A single EM-driver is used for both the EM-80 and the EM-300. Only the software

setup for each actuator system differs. Monitoring, alarm, and diagnostics are available.

An EMI power filter is supplied to suppress emissions.

Optional Features

The EM-80 and EM-300 systems include a bracket for mounting on the engine or turbine.

A standard mounting hole pattern is provided. Alternative patterns are available on request.