Compatible with non-DeltaV Switches

The DeltaV Smart Switch also can be installed in a new system

mixed with the currently supported and shipping Cisco or

Hirschmann switches.

Please read DeltaV Books-on-line for important information

when retrofiting into existing DeltaV networks, especially in

systems with existing 3COM switches or media converters.

Fiberoptic connections on DeltaV Smart Switches are non

configurable and communicate only at 100Mbps on the DeltaV

ACN or 1Gbps switch-to-switch at full duplex.

Installing DeltaV Smart Switches into systems with existing

fiberoptic devices that are not set to 100/1000Mbps full duplex

will cause communications disruptions in the network.

Use outside of the DeltaV Control Network

The DeltaV Smart Switches is supported only as an unmanaged

switch if installed in networks outside of the DeltaV control

network, the DeltaV 2.5 network between the DeltaV

workstations and the perimeter firewall (such as the Emerson

Smart Firewall), or other DeltaV networks external to the DeltaV

control network. The switch will only accept a management

port network address from the DeltaV Network Device

Command Center and the switch can only be used where this

application is able to access the switch.

The DeltaV Smart Switches is not available for use as a managed

switch in the DeltaV InterZone network as the DeltaV Network

Device Command Center cannot access the switch if located on this network.