INSTALLATION

BE3 ac voltage relays are designed for mounting on standard DIN

rails that comply to DIN-EN 50022. Mounting involves hooking the

top edge of the cutout on the base of the case over one edge of the

DIN rail. The opposite side of the cutout containing the release clip

is then pushed over the opposite side of the DIN rail. To remove or

reposition the relay, lever the release clip and move the relay as

required. BE3 relays should be installed in a dry, vibration-free

location where the ambient temperature does not exceed the

operating temperature range. Connections to the relay should be

made using wire that meets applicable codes and is properly sized

for the application. Figure 1 shows the terminal connections for the

BE3-27T, BE3-59T, and BE3-27T/59T relays.