Features

Separate fuses for test terminal, voltage sensing and motor power are on

the front panel, and spare fuses for each are located in the fuse holder.

Binding posts on the front panel allow easy connections for test procedures.

RAISE/OFF/LOWER, AUTO/OFF/MANUAL and VOLTAGE SOURCE switches,

DRAG HANDS RESET pushbutton, and NEUTRAL LIGHT are standard.

AUTO/OFF/MANUAL switch may be configured for switch status detection.

NEUTRAL LIGHT will light to indicate that the regulator is in the neutral

position, for those regulators equipped with a circuit for this purpose.

Options

SCADA CUTOUT switch allows Local blocking of SCADA commands (for use

with SCADA enabled M‑2001C controls). The SCADA Cutout switch must

be used with a M-2001 Series Control with firmware version D‑0146V08.01.22

or later installed.

SCAMPTM (SCADA Controllable Auto/Manual Pushbutton) switch allows the

Auto/Manual state on the adapter panel to be changed by a SCADA command.

The SCAMP pushbutton switch must be used with a M‑2001 Series Control

with firmware version D-0146V08.05.XX or later installed.

Voltage Reduction switch allows 2 levels of Voltage Reduction to be selected.